Cheddas Auto Panhard bar installation

Various setups, tips, etc.

Moderators: Ami, evtsteward

Topic Author
G1 n00b
Posts: 14
Joined: October 15th, 2016, 5:23 pm

Cheddas Auto Panhard bar installation

Postby aarongolesch » April 22nd, 2017, 9:52 pm

Here's a quick guide to installing the panhard bar for your integra....

This is a very easy process that only requires about 20-30 minutes of your time.

1. First, you want to jack the rear of the car up on both sides, you do not have to remove the wheels.

2. You will see that on the passenger side, there is a 17mm nut with a washer on it. It is recommended that you take a hammer and give the nut/bolt a few whacks to loosen it up. This hardware has probably been on there since 1988.


3. Go to the drivers side. There is a 17mm bolt on that side that goes thru to a welded nut. Give it a whack with the hammer to get it loose.


4. Once the hardware has been removed, the stock panhard bar may take a few whacks to get it to fall down. Remove old bar.


5. The new bar already comes pre-lubed. Install the same as how you removed it. Adjust the bar by loosening the jamnuts and twisting the bar to extend it. One of the nuts is reverse threaded so keep an eye out for that. Make sure to put locktite back on the hardware when installing it.


User avatar

Site Admin & Crunkass Teg Mechanic
Posts: 847
Joined: January 28th, 2007, 7:05 pm
Location: Marysville, Wa 98270

Re: Cheddas Auto Panhard bar installation

Postby evtsteward » April 23rd, 2017, 3:18 pm

Nicely done sir!
Robert, that crazy guy with all the tegs!
Always an honor to be quoted.-B18Ch1ck
The great ships hung in the air in much
the same way bricks don't.-Douglas Adams

The value of life can be measured by how many
times your soul has been deeply stirred.-Soichiro Honda

Return to “Chassis/Suspension/Brakes/Wheels/Tires”

Who is online

Users browsing this forum: No registered users and 0 guests