Page 1 of 1

crankshaft pulley needed

Posted: April 19th, 2016, 7:35 am
by veebajet4
i need a crankshaft pulley for my 88 integra,i have the 24mm snout,got one from a salvage yard the size is 22mm,im in sacramento ca ,asap,the lip where the power steering belt broke off ,mechanic made a mistake using a chain type wrench to hold pulley to loosen nut,while changing my timing belt,after tbelt and waterpump was installed and belts put in place cranked engine and piece of the lip broke off,been driving without power steering is that ok till i find the right 24mm pulley

Re: crankshaft pulley needed

Posted: October 12th, 2016, 7:48 am
by veebajet4
pulled a pulley from a 1989 integra they use the bigger 24mm crankshaft snout.87s to early 88s use the smaller 22mm