Was wondering ?

Body, gauges, seats, spoilers, etc. Also electronics, audio, and detailing.

Moderators: Ami, evtsteward


Mr NW Classic

Re: Was wondering ?

Postby Mr NW Classic » August 12th, 2014, 1:01 am

90-93 Integra seats bolt in with minor mods.


Mr NW Classic

Re: Was wondering ?

Postby Mr NW Classic » August 13th, 2014, 4:23 pm

No just the fronts.

User avatar

Mikakey
Legit G1Tegger
Posts: 124
Joined: May 31st, 2014, 5:49 am
Location: Plattsburgh, NY 12901

Re: Was wondering ?

Postby Mikakey » August 13th, 2014, 6:23 pm

Someone had told me about the rears fitting once. Maybe with a little modification?

Sent from my Z796C using Tapatalk
Blue 1987 Integra
B20VTEC with Stage 2 Exedy clutch and lightweight flywheel, DC headers, custom exhaust with APEXi muffler, and Hondata S300 tune.
Upgrade Motoring 27.5mm torsion bars with KYB GR-2s and B&G rear springs.


bucd
G1 n00b
Posts: 30
Joined: April 9th, 2014, 4:39 pm

Re: Was wondering ?

Postby bucd » August 15th, 2014, 11:33 am

I was researching this recently as well, i'm looking at trying to get 5th gen prelude seats to fit. Here's a good thread i found on another forum that list what gen seat fits what.
http://www.utahhondas.net/index.php?topic=35678.0

And if you are up to it, you can swap the pan and you can pretty much take any gen and make it fit. I just don't know about some of the typically flaws that he shows on there, if going that route, i'd say to research ones that is closest to ours and use that gen.

There use to be a thread on here on 3rd gen seat and i believe it was just swapping out rails.

Good luck!

-D


Return to “Interior/Exterior/ICE/Detailing”

Who is online

Users browsing this forum: No registered users and 1 guest